AirNav Radar ADS-B 1090 MHz Outdoor Antenna with SMA Connector
$99.95
Price: $99.95
(as of Nov 07, 2025 09:27:21 UTC – Details)
High performance, omni-directional Antenna optimized for long & short-range ADS-B ADS-B 1090 MHz reception. Shipped with a 30 ft cable and SMA connector. Compatible with any AirNav RadarBox ADS-B receiver and with other similar SMA connector receivers. Built with fiberglass & aluminum alloy for both indoor/outdoor use. Guaranteed 50-100 nm range improvement.
High performance ADS-B 1090 MHz Vertical Antenna with SMA connector.
Gain 7dBi, Impedance 50Ω±5Ω, Vertical Polarization
66 cm / 26 inch Vertical Antenna. 20 mm diameter / width.
Built with fiberglass & aluminum alloy for both indoor/outdoor use.
Tested in extreme weather conditions.
Mounting bracket and 30 feet co-axial cable included.
Customers say
Customers find the antenna easy to install and consider it good value for money. However, the performance and reception receive mixed feedback – while some say it works well and improves reception significantly, others report it doesn’t receive anything and has worse signal strength. The build quality also gets mixed reviews, with one customer noting the cable is high quality while another finds it worse than a mini antenna.
Israel –
Sam performance than FlightAware antenna
I have 7 flightaware antennas and they works ver well. I bought one AirNav Antenna and after one month I saw same performance that flightaware antenna, with difference that cable length is 10 m (my flightaware system has 4,5 m length), then I can put my decoder and rpi inside my house, and is cheaper than flightaware system (AirNav antenna with cable $50; flightaware antenna and LR400 cable I spent $75)… I recommend this antenna!
Starslayer –
Installation
Easy to install.30′ cable length was long enough for my purpose.I used an old Dish antenna mount to attach it to.The tubing diameter was a bit large for the u-bolt provided.The diameter of the antenna is about 7/8″. U-bolt provided is closer to 1-1/4″I had to squeeze the tubing about an 1/8″ and it worked fine,
Robsters –
3X improvement! Wish I got this sooner.
Purchased this to upgrade from a smaller magnetic antenna, I kept looking for reviews showing what kind of change to expect. See my screenshot, using this this indoors (garage), it’s connected to a RPI with a band pass filter, I went from getting almost no positions beyond 50 miles. In my screenshot graph, I’m now getting almost twice the positions greater than 50 miles away than ALL the positions under 50 miles away.This came with hardware to mount to a pole, I mounted it to a tall storage rack in the garage. Which worked great with the long cable it comes with to keep the RPI within easy each of an electrical outlet and arms reach now.Using this to feed FlightAware, RadarBox24 and ADSBExchange from a single Raspberry Pi 3, using the USB FlightAware Pro Stick and the ADS-B Band-Pass SMA filter.
David P Totten –
Works great for me!
Ok, so I haven’t had a chance to use this much, or even in a proper way yet, but I’m getting very good reception with it. I have used it indoors just laying on the table and it picked up most of the planes in the Las Vegas area. I’m using it with SDRuno. And a SDRplay receiver.
Steve –
Works ok but coax but no coax connector on Antenna can make installation difficult.
The antenna itself works ok, I’m getting good ADSB coverage…. So that is the good part.. The things I don’t like about this antenna are:1) Connection of coax to the antenna is a pigtail (can’t be disconnected). Most antennas like this will have an “N Type” connector that mates with the Coax and then an SMA on the far end (at the receiver side). What this means is that without making modifications.a) You are stuck with the relatively high loss coax that is affixed to the antenna (haven’t found out what it is yet as it isn’t marked. I’m assuming it is something like RG58). I had to cut the coax near the antenna base and put a connector on to mate with a higher quality coaxb) Even more important is that without modifying you can’t easily add a lightning arrester near the antenna. Again, I cut the coax and added mine.All in all the antenna isn’t bad, but is kind of hobbyist for the reasons stated.can’t easily use a different (eg Larger Coax for longer runs)
Jason M. Sullivan –
Mostly fine, but marred by an un-replaceable cable.
The antenna works well enough, but it’s got a 32-foot cable with an SMA connector at one end and bonded directly to the antenna at the other end. While fewer connectors does reduce loss, it means that if your cable breaks (as mine did) you’re out the whole device or left to try and repair the cable instead of replacing it.
DGA –
Worth the money!
It’s not the most expensive antenna available on the market (you can go wild spending A LOT of money to improve reception). But it was the money well spent. I used a small magnetic antenna and decided to give the new antenna a shot. The difference is huge! I believe the cable is high quality as the reception is strong and losses are low.Can’t compare with similar antennas but it’s a huge win over small magnetic brothers!
MadPB –
Almost zero reception… a bare piece of wire would be better
Maybe I got a defective unit. I replaced a basic stubby antenna that was pulling in signals from 30-45 miles away but I thought I could up my game by getting a dedicated outdoor unit.I placed this outside just above the roof line, same spot (actually a little higher thanks to the longer cable) as the old one and fired up my dump1090. Well, it was only able to pick up some signals from about 5 miles. What? I hooked up the old antenna cable, inside now, and watched the # of tracked planes jump up immediately… and this stubby was now inside my metal roofed structure.Well crumb – I hooked this antenna up to my HackRF and used SDR# to view 1090MHz and it’s just super weak – just a terrible signal coming in compared to what I see on the waterfall with even a cheap adjustable length antenna.I’ll be returning this and probably going for the FA model. I was hoping this would be good enough and I liked that it came with the cable, but in hindsight that might actually be it’s downfall – the permanently attached antenna may be at fault, and/or it’s just too long so that it’s attenuating so much that it loses whatever gain the antenna was adding. With the FA model, sure, the cable is a separate purchase, but you can get the length you need and get a high quality one if needed. Instead of 25′ of whatever this cable is, I probably only need about 15′ and I may as well just get LMR-400 for the low loss.
James –
Ok, lets give this antenna a fair comparison. The kit I’m using is a Raspberry Pi4, running Bookworm and PiAware 10.1, both supported by FlightAware – no need to be a Linux geek here. Receiver is the FlightAware Plus (which has the filter in it), and the existing antenna is the YILIANDUO 5DBi 1090MHz Antenna SMA Male Plug Indoor ADS-B Aerial with Magnetic Base RG174, which is sitting on a first-floor window sill, facing East.Living in Kettering as I do, almost all the ADS signals I’ve been receiving to date have been within a 50-mile radius of me. I put this antenna (vertically) alongside the existing one and changed over the connectors. Within a few minutes, I was picking up signals from 60-70 miles away, and this now seems to have settled down to some 85% within the 100-mile radius, however, the remaining 15% fall within the 100-150 mile range, meaning I now cover most of England and Wales – I do regularly see signals from aircraft North of Anglesea, and track others right out into the North Sea. At this stage, the antenna is still only on the window sillAll in all, definately a worthwhile investment.EDIT: Taken an alternative fixing method for the time being – I’ve used 4 aquarium heater suckers, with ty-wraps to secure the antenna to the outside of the window – I do very occasionaly recieve signals from the 200-250Nm range – looking forward to getting it mounted on the tv mast above the ridge line.
Massimo –
Ottima antenna fatta bene con 10m di cavo intestato,provata interno abitazione ricezione buona,prossimamente la installero’ sul tetto per migliorare l’rx
tom aski –
deze ads-b antenne werkt perfect en is makkelijk aansluitbaar via de sma connector aan het einde van de kabel. aan de antenne zelf is de kabel fabrieksmatig vast gemaakt, zo kan die niet loskomen en ook niet roesten. top product!
david –
J’ai eu chaud, j’ai eu chaud, OMG, je me suis fait volé mon colis et retourner par magie. Bref l’important c’est que toute est rentrée dans l’ordre et que je suis satisfait du produit que j’ai commandé. Toute est A1👍👍
Jorge –
Vengo de otra antena con resultados infinitamente peores. Mi ubicación no es la mejor, pero aún así tengo datos de cientos de kilómetros de distancia.Merece la pena la inversión.